KEVWire

Security intelligence, with context.

Response snapshot Oct 26, 2026, 23:55 UTC

Back to the wire
Permalink
VulnerabilityCVE-2026-79976

The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and...

The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and then writes or reads payload bytes.

Published Updated

At a glance

Exploited
Not known
Severity
7.1 High (CVSS 3.1)
Chance of exploitation
0.3% in the next 30 days
Sources
1 source

What to do

Check the vendor advisory for affected versions and fixes.

Read NVD CVE-2026-79976 (opens a new tab)

What happened

The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and then writes or reads payload bytes.

The selected register (b->reg_addr) and the data-phase flag (b->rxtx) were never cleared when the controller issued an I2C STOP, so after a completed transfer the target still had a data register selected while the packet buffer that register refers to had already been consumed and set to NULL by mctp_i2c_gpio_target_stop().

A controller on the bus can re-enter the same branch of mctp_i2c_gpio_target_stop() with a NULL buffer using two ordinary transactions and no authentication: first a normal packet write to MCTP_I2C_GPIO_RX_MSG_ADDR followed by STOP (which delivers and frees b->rx_pkt), then a bare read transaction followed by STOP.

The failing read_requested() call leaves the stale state untouched and the I2C driver still delivers the STOP callback, which then calls mctp_bus_rx() with a NULL packet.

Continue reading

The symmetric case exists on the transmit side, where the stale MCTP_I2C_GPIO_TX_MSG_ADDR selection dereferences b->tx_pkt->end after b->tx_pkt has been cleared and additionally signals b->tx_complete a second time, causing the next outbound packet to be dropped.

The dereference happens in the I2C target interrupt handler, so on any target that traps accesses to address 0 the result is a fatal exception and a device reset or halt — a denial of service inflicted by any device able to act as controller on the shared management bus (for example compromised firmware on a peer MCTP endpoint or on the BMC).

On parts where address 0 is readable, the impact degrades to a malformed packet buffer being handed to the MCTP stack and lost transmit packets. No attacker-controlled value is written and no confidentiality or integrity boundary is crossed.

The fix resets b->reg_addr to MCTP_I2C_GPIO_INVALID_ADDR and clears b->rxtx at every STOP, so a new register must be selected before any data phase can run again. Only builds that opt into the experimental CONFIG_MCTP subsystem with CONFIG_MCTP_I2C_GPIO_TARGET=y are affected.

Scores and how they were measured

CVSS base severity

7.1

Version 3.1As of

CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:L/I:N/A:H

Measurement source (opens a new tab)

How bad it is if exploited. Not a prediction of exploitation or proof you are exposed.

EPSS probability

0.3%

Scored Percentile 17.1%

Model and measurement source (opens a new tab)

A model's estimate of exploitation in the next 30 days, not certainty or your own risk.

Sources

  1. Primary source

    NVD CVE-2026-79976 (opens a new tab)

    NVD record: description, CVSS (the CNA score is preferred), affected products, and publication date. Not evidence of exploitation.

    Published Checked

  2. Primary source

    NVD CVE API 2.0 (opens a new tab)

    The NVD API page that supplied this CVE record.

    Published Date not suppliedChecked

  3. Primary source

    FIRST measured EPSS score (opens a new tab)

    Measured EPSS probability and percentile for CVE-2026-79976, scored 2026-10-26. This is a model estimate, not proof of exposure.

    Published Checked

Cite this record

For factual claims, cite the primary sources above; cite KEVWire for its compilation, dates, and classifications.

APA

KEVWire. (2026, October 23). The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and... (CVE-2026-79976). https://kevwire.com/record/CVE-2026-79976

MLA

"The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and... (CVE-2026-79976)." KEVWire, 23 Oct. 2026, kevwire.com/record/CVE-2026-79976.

Chicago

KEVWire. "The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and... (CVE-2026-79976)." Last modified October 23, 2026. https://kevwire.com/record/CVE-2026-79976.

Evidence summary (plain text)

The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and... (Oct 21, 2026).
The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and then writes or reads payload bytes. The selected register (b->reg_addr) and the data-phase flag (b->rxtx) were never cleared when the controller issued an I2C STOP, so after a completed transfer the target still had a data register selected while the packet buffer that register refers to had already been consumed and set to NULL by mctp_i2c_gpio_target_stop().

A controller on the bus can re-enter the same branch of mctp_i2c_gpio_target_stop() with a NULL buffer using two ordinary transactions and no authentication: first a normal packet write to MCTP_I2C_GPIO_RX_MSG_ADDR followed by STOP (which delivers and frees b->rx_pkt), then a bare read transaction followed by STOP. The failing read_requested() call leaves the stale state untouched and the I2C driver still delivers the STOP callback, which then calls mctp_bus_rx() with a NULL packet. The symmetric case exists on the transmit side, where the stale MCTP_I2C_GPIO_TX_MSG_ADDR selection dereferences b->tx_pkt->end after b->tx_pkt has been cleared and additionally signals b->tx_complete a second time, causing the next outbound packet to be dropped.

The dereference happens in the I2C target interrupt handler, so on any target that traps accesses to address 0 the result is a fatal exception and a device reset or halt — a denial of service inflicted by any device able to act as controller on the shared management bus (for example compromised firmware on a peer MCTP endpoint or on the BMC). On parts where address 0 is readable, the impact degrades to a malformed packet buffer being handed to the MCTP stack and lost transmit packets. No attacker-controlled value is written and no confidentiality or integrity boundary is crossed.

The fix resets b->reg_addr to MCTP_I2C_GPIO_INVALID_ADDR and clears b->rxtx at every STOP, so a new register must be selected before any data phase can run again. Only builds that opt into the experimental CONFIG_MCTP subsystem with CONFIG_MCTP_I2C_GPIO_TARGET=y are affected.
CVSS 7.1 (version 3.1; evidence as of Oct 23, 2026; https://nvd.nist.gov/vuln/detail/CVE-2026-79976).
EPSS 0.3% for the following 30 days, scored Oct 26, 2026 (https://api.first.org/data/v1/epss?cve=CVE-2026-79976&date=2026-10-26).
Sources:
NVD CVE-2026-79976: https://nvd.nist.gov/vuln/detail/CVE-2026-79976
NVD CVE API 2.0: https://services.nvd.nist.gov/rest/json/cves/2.0?pubStartDate=2026-10-12T13:35:55.142Z&pubEndDate=2026-10-26T13:35:55.142Z&resultsPerPage=500&startIndex=8000
FIRST measured EPSS score: https://api.first.org/data/v1/epss?cve=CVE-2026-79976&date=2026-10-26
Record ID: CVE-2026-79976.
Record origin: Ingested record.
AI evidence: Not assessed.
Known exploitation: Not assessed.
Zero-day status: Not assessed. KEV membership alone does not establish zero-day status.
About this data

This record was ingested from a data source. Retrieved: Oct 26, 2026, 19:40 UTC. Ingestion is not an independent editorial investigation.

NVD status: Awaiting Analysis. Publication in the NVD is not evidence of exploitation.

A CISA KEV listing documents known exploitation, not necessarily a zero-day; absence from the catalog does not prove a vulnerability has never been exploited.

Technology tags indicate possible relevance, not verified exposure. Confirm the affected product, version, and configuration against your own inventory; KEVWire does not scan your systems.

A personal reading checklist on this device, not verified remediation.

Record JSON

Your account

Email alerts

Email alerts are not available yet. To follow your stack today, use its RSS feed, which honors your filters, or connect an AI agent through the API.

Suggest an improvement

Ideas, missing sources, corrections, and bugs are all welcome. No account needed. Suggestions are reviewed by a person before anything changes.

Record details

Record detail